Table:
- Table Size: 146" x 40"
- Maximum Table Load: 10000 Lbs
Travels:
- X-Axis Travel: 150"
- Y-Axis Travel: 50"
- Z-Axis Travel: 50"
Spindle:
- Spindle Speeds - Maximum: 7500 RPM
- Spindle Taper: CT 50 Taper
- Main Motor (30 min. / cont.): 30 HP
Tool Changer:
- Tool Changer Positions: 30+1 ATC
Rapids:
- Rapid Traverse (XY/ Z): 500 /710 IPM
General:
- Floor Space Required (L x W): 31 ft x 17 ft
- Height with head all the way up (approx): 141"
Equipped With:
- 2-Speed Geared Head
- 30 Position Side-mount tool changer
- Remote Jog Handle, Color LCD
- X-axis linear scales
- Intuitive Probe System
- Through Spindle Coolant
- Rigid Tapping
- 95-Gallon Coolant Tank
- Chip Auger
- Programmable Coolant Nozzles
- Intuitive Probing, Renishaw
- Expanded Memory
Comments:
- Power On - 10,219 hours
- Cycle Start - 4186 hours
- Cutting - 3564 hours
- Machine cost when new was $404,000
- Machine build new was completed in Feb. 2014 - current owner took delivery
- several months later.
- Here are irepairs that have been made to this machine:
- 1. new rails skates - not sure haas says they just wear some times
- 2. Encoder - has a coolant leak that messed up
- 3. Counter balance cylinder has very very slow leak we have the guage
- to fill maybe once a year
- 4. New spindle not sure why bearing locked up. We had it rebuilt by Setco
- in Cincinnati
- 5. One of the chip auger motors is out. We just didnt fix it - it works fine
- 6. Tool setter is out being repaired by Renishaw. It just did communicate.
- Probe works great.
- I want to be completely honest and up front because I would like to be treated
- the same.
- Machine has been a great machine and as anyone knows ALL machines has
- some little issue over all we are selling because only 4% of our work is required
- to go across this machine
- We are planning to replace with smaller machines
- We have the guards we took off. It just easier putting big piece in it. The
- coolant still stays contained.
|