Specifications:
- Width between columns: 80"
- X-Axis Table Travel: 157"
- Y-Axis Spindle Head Travel: 78"
- Z-Axis Spindle Quill Travel: 18"
- Distance from spindle to table, Min - Max: 0" - 59"
- Size of table, width x length: 60" x 162"
- Cutting feedrate: 0.04 to 393 IPM
- Rapid traverse rate: 787 IPM
- Spindle diameter: 3.94"
- Spindle taper: BT 50
- Spindle speed range: 30 to 4,000 RPM
- Quill diameter: 8.27"
- Tool stations: 72
- Main motor: 30 / 25 HP
- Machine height: 17 foot
- Floor space: 40 ft W x 18 ft L
- Machine weight: 86,900 lbs
Equipped With:
- OSP P200M CNC
- Complete Set of Manuals
- Some Tool Holders
Comments:
- 6 Ft will come off the height when the pendant if removed
- New cost today: About $ 1 Mil. Delivery: 12-18 months.
- The machine is under power and in GOOD TO VERY GOOD
- CONDITION. It was purchased to manufacture whip stock, which is an
- angular down hole tool that used to be used for offset drilling.
- Mud motors, directional drilling and MWD (Measure while drilling) made
- whipstock obsolete. It has been kept under power in an air-conditioned and
- heated building.
- Ten years ago, new owners purchased the facility. The machine has not been
- used since the new owners purchased the facility. Last year Okuma come in
- and powered up the machine. The batteries were dead. They were replaced,
- parameters reinstalled and the machine cycled.
|